how to install resistor for egt sensor on uppipe
#6
Registered User
iTrader: (6)
Join Date: Jan 2007
Location: Walnut Creek
Posts: 793
Car Info: 2002 MBP WRX
If I might add (Since I did this recently) You need to make sure that it's very secure in there. If it bumps out at all, it will set your CEL back on (like mine did).
Also, I suggest disconnecting your battery and reset your ECU before turning it back on after placing the resistor into the connection.
You also need to not force the resistor into the connection, it will bend easily if you do. I'm not sure if other people have had the thing sticking out, but I snipped the leads a bit and placed it in to be flush down into the connection, folded up some electrical tape over it and then taped the entire connection closed.
- Kevin
Also, I suggest disconnecting your battery and reset your ECU before turning it back on after placing the resistor into the connection.
You also need to not force the resistor into the connection, it will bend easily if you do. I'm not sure if other people have had the thing sticking out, but I snipped the leads a bit and placed it in to be flush down into the connection, folded up some electrical tape over it and then taped the entire connection closed.
- Kevin
Thread
Thread Starter
Forum
Replies
Last Post
tscott915
Wanted
1
10-01-2009 06:46 AM
Smooth_Ej20
Engine/Power - EJ20T (pre-2006 WRX and JDM)
4
01-19-2005 09:42 AM
spdkills
Engine/Power - EJ20T (pre-2006 WRX and JDM)
5
09-30-2003 11:28 PM
spdkills
Engine/Power - EJ20T (pre-2006 WRX and JDM)
4
01-25-2003 03:48 PM