Hey! As some may know, I just bought a glowshift Boost Gauge (52mm). I was wondering if anybody can help me properly install the gauge! I'll buy you lunch or give you a nice pat on the back haha. HELP ME OUT!

 

just did an oil pressure gauge and an electronic boost gauge on an 11'. and i did my spt boost gauge on my 10... pm me

 

Learn to search Alan... This has been done many times.. haha. jkjkjk <3 no homo. Run the tube from the boost gauge either through your harness via passenger side or through the drivers fender. I did mine through the fender. There is a grommet in your footwell and there should be a spot were you can cut it and run the tube through to the commander in your engine bay. Takes about 30mins or so, just get a coat hanger to help route it up into the engine bay and remove the liner. It is ten times easier to do it that way and dont have to worry about puncturing anything in the harness.

 

In the near future I will be shooting you a pm hahah

 

sounds good. i love working on subies!

 

I dunno, the grommet on the passenger side was pretty easy to go through. though you need a lot of hose/wire to go that way.

Alan, is it a mechanical or electrical gauge? Why Glow****?

 

success! nice chillin alan.
hey if you want any other front plate deletes made, need your tails done right, or whatever else, hit me up bro.

 

Hopefully in the next few months I will be running a windows based Tablet for my gauges haha.

 

THANKS BRO!

IF YOU I-CLUB PEEPS WANT YOUR GAUGES INSTALLED BY JAMISON, HIT HIM UP! HE CAN BEAT THE LOCAL CAR SHOP PRICES ANYTIME!

p.s. that job you are getting me is very promising! thanks lol