Help with installing boost gauge
#1
Help with installing boost gauge
i read the OEM subaru instructions and some threads on scoobymods so i have the basics down, just not sure where to find some things.
1) there are two rubber stoppers behind the intercooler, which one do i use to put the rubber hose through? the one with an impressed groove (smaller) or flat one (larger)? where does it come out in the compartment? i can't see any holes by the gas pedal.
2) where can i tap 'dimmed' power, possible from the gauge cluster? i will take apart the center console to get the one above the stereo if that is the only one available but would rather not do all that work. for that connector, what size spade connectors can i use or should i just strip the wires?
thanks
1) there are two rubber stoppers behind the intercooler, which one do i use to put the rubber hose through? the one with an impressed groove (smaller) or flat one (larger)? where does it come out in the compartment? i can't see any holes by the gas pedal.
2) where can i tap 'dimmed' power, possible from the gauge cluster? i will take apart the center console to get the one above the stereo if that is the only one available but would rather not do all that work. for that connector, what size spade connectors can i use or should i just strip the wires?
thanks
Thread
Thread Starter
Forum
Replies
Last Post
AlanNgo7
General Tech / How To's / Installations
8
06-11-2011 01:34 AM
cdawg
NorCal Classifieds
0
01-04-2008 03:44 PM
aznfoos
Engine/Power - EJ20T (pre-2006 WRX and JDM)
5
03-19-2004 08:05 PM
mattr762
Engine/Power - EJ20T (pre-2006 WRX and JDM)
6
04-18-2003 09:12 AM