newbie question - springs
Thread Starter
Registered User
Joined: Dec 2005
Posts: 628
From: CA
Car Info: '06 black 2.5i
newbie question - springs
hey guys,
I got an 06 2.5i...
I'm buying lowering springs next week and i was wondering about installation. Do people normally lower it themselves or do they have it done at a shop? is it pretty tough?
I got an 06 2.5i...
I'm buying lowering springs next week and i was wondering about installation. Do people normally lower it themselves or do they have it done at a shop? is it pretty tough?
Registered User
iTrader: (15)
Joined: Aug 2005
Posts: 12,522
From: Salinas, CA
Car Info: 1997 Acura Integra GS Sedan
you'll need a good set of tools, high mm rachet set (17mm, 19mm), a spring compressor set which you can get from kragen's or Autozone (they have loner's), a jack, some jack stands, and some extra cash to get the alignment done at the end. Where are you located in cali? I may be able to help me. You can PM me your location if you want...
it's not really a tough job, but just a tedious one, especially your first time
it's not really a tough job, but just a tedious one, especially your first time
Thread Starter
Registered User
Joined: Dec 2005
Posts: 628
From: CA
Car Info: '06 black 2.5i
Originally Posted by SubyN00by
you'll need a good set of tools, high mm rachet set (17mm, 19mm), a spring compressor set which you can get from kragen's or Autozone (they have loner's), a jack, some jack stands, and some extra cash to get the alignment done at the end. Where are you located in cali? I may be able to help me. You can PM me your location if you want...
it's not really a tough job, but just a tedious one, especially your first time
it's not really a tough job, but just a tedious one, especially your first time
Thread
Thread Starter
Forum
Replies
Last Post
wombatsauce
Engine/Power - EJ20T (pre-2006 WRX and JDM)
20
Jan 19, 2003 05:53 PM