Fluke directional problem with jdm hids
Thread Starter
Registered User
iTrader: (-1)
Joined: Apr 2003
Posts: 369
From: Litchfield, NH
Car Info: 03 yellow WRX stage 1
Fluke directional problem with jdm hids
Whenever I turn on the parking lights or headlights the left blinker doesnt work. The blinker on the gauges and the exterior blinker doesnt work. Where do I start to look and what do I look for?
sounds like a problem with the relays.
when you swapped in the jdm lights, what all did it involve?
im thinking the relay that controls the turn signals isnt getting the correct signal. i dont have the presence of mind right now to think this through correctly, but i would check and compare the grounding points for the left turn signal with that of the right turn signal. maybe a wire was crossed or not grounded correctly during your install.
when you swapped in the jdm lights, what all did it involve?
im thinking the relay that controls the turn signals isnt getting the correct signal. i dont have the presence of mind right now to think this through correctly, but i would check and compare the grounding points for the left turn signal with that of the right turn signal. maybe a wire was crossed or not grounded correctly during your install.
Last edited by jwrx; Aug 28, 2005 at 10:09 PM.
Thread Starter
Registered User
iTrader: (-1)
Joined: Apr 2003
Posts: 369
From: Litchfield, NH
Car Info: 03 yellow WRX stage 1
Did just what I said and found out that the ground going to the left blinker was switched with one of the others so I spliced and soildered, yAhoo! Everything is ok now... but my horn.. check my "no honk" thread.
Thread
Thread Starter
Forum
Replies
Last Post
Toiletbrush
Suspension, Handling, and Brakes
4
Jun 21, 2005 12:08 AM



