ok i bought the hks harness for my blitz dtt turbo timer. i took out the bootom panel under the sterring wheel and found the blue male/female piece.

thats where it stops i have no idea what side to plug into where. the harness has three ends. so confusing. please anybody have a clue what to do? shouldnt it just be plugnplay?

MAHALO

 

lol, on the hks harness is there two connectors that are closer to each other? connect those to the car's ignition harness and the single end to the tt.. i dont think it will plug any other way than the correct way...

 

i tried that but then the end that is not close is a female connection with only three slots. the tt has 4 prongs.

 

wierd, stupid question but u go the right harness? i do remeber the 4 prong on mine... dang it lemme go look at mine haha

 

aight i see whats going on.. the hks harness has 3 prongs on all of the connectors. the tt should have came with a wire harness, one end would have four prongs( to the TT) and the other with three which should go to the hks harness...

 

k i took my stuff all out.. check the pic. u can still wire it up with out that, u just gotta know which prong is which and which one the ground is... hope this helps