i have a Greddy EGT gauge that i plan on installing while doing my header/uppipe/downpipe install tom. but while playing with the probe i can't figure out how it is supposed to stay put. i looked at the directions and did a search but found nothing. i know the longer part of the "mount" goes into the bung and then you have a nut and some little fitting inside of it that is supposed to secure the probe but i just can't seem to get it to secure the probe. am i missing something here? any help is greatly needed.

Thanks
H. Phillips

 

Hey Peaty,
Sorry to constantly illicit your advice, but you seem to be the most knowledgable. You appear to have great knowledge of specifics. Can You help this guy? Great to have You as a moderator!
Sincerely, Collins