trannsmission install problems
03-07-2009, 02:10 PM
#1
Registered User
Thread Starter
iTrader: (5)
Join Date: Oct 2007
Location: family sedan 05 caddy sts v8
Posts: 549
Car Info: sold: 06 wrx
transmission install problems
ok so i busted 3rd gear 2 weeks ago. had the tranny repaired by a shop. i am trying to install the transmission but am having trouble. i have the two bottom studs on and the input shaft of the tranny is slid into the clutch/motor already. so my question is if i can use the bolts and studs to tighten the tranny down already? (there is about 1/2 inch gap between tranny and motor)... or do i have to slide the tranny flush with the engine before i can bolt it back up? help me please!
Last edited by achavez; 03-07-2009 at 02:24 PM.
Thread
Thread Starter
Forum
Replies
Last Post
grex767
Engine/Power - EJ20T (pre-2006 WRX and JDM)
6
05-27-2006 10:37 AM
Zoeb2s
Engine/Power - EJ20T (pre-2006 WRX and JDM)
3
06-13-2003 05:58 PM