AT Sticking in 1st
Guest
Posts: n/a
AT Sticking in 1st
This is a first for me... 2000 Outback Sedan, 4spd AT.
Every now and then the AT will have a hard downshift into 1st, then will not shift up to 2nd, 3rd, 4th, either when the shift lever is in D or I move it up from 1, 2, 3, D etc.
Then, inexplicably, it will shift just fine.
I've had the transmission serviced at the dealer (Fluid/filter change), but no codes have been thrown at any time. Anyone else have this happen, or have any ideas of what could be causing it? I assume that if a shift solenoid were going bad, a code would be thrown?
-H-
Every now and then the AT will have a hard downshift into 1st, then will not shift up to 2nd, 3rd, 4th, either when the shift lever is in D or I move it up from 1, 2, 3, D etc.
Then, inexplicably, it will shift just fine.
I've had the transmission serviced at the dealer (Fluid/filter change), but no codes have been thrown at any time. Anyone else have this happen, or have any ideas of what could be causing it? I assume that if a shift solenoid were going bad, a code would be thrown?
-H-
Thread
Thread Starter
Forum
Replies
Last Post
jdmpwrdr
Engine/Power - EJ20T (pre-2006 WRX and JDM)
4
Jan 17, 2004 05:57 AM