06 WRX flashing cruise control but NO CEL
Thread Starter
the artist formerly known as mcdrama
iTrader: (23)
Joined: Apr 2004
Posts: 6,428
From: Santa Cruz Mountains, CA.
Car Info: WRBP 2015 WRX Premium/CVT
Seriously, an evap code will get thrown for a loose gas cap. Pressure needs to build in your tank. If the pressure isn't where it needs to be, you get a code. This happens to me when my wife fills up. I just tighten the cap and the code eventually goes away. I'm not being a jackass.
updating first post.
banned
iTrader: (13)
Joined: Oct 2007
Posts: 2,746
From: Walnut Creek Ca..
Car Info: heel'n toe da hoe...
Have you logged anything on that map? Post the log sheet.
You can log the evap.
Seriously, an evap code will get thrown for a loose gas cap. Pressure needs to build in your tank. If the pressure isn't where it needs to be, you get a code. This happens to me when my wife fills up. I just tighten the cap and the code eventually goes away. I'm not being a jackass.
Registered User
Joined: Nov 2002
Posts: 648
From: Santa Cruz, California
Have any of you BAIC folks seen this and better yet fixed it?
I zeroed the OL/CL table to zero in the 3 table cells of the stock downloaded map and ran fine for about a month. The car is 100% stock.
My friend(the owner) had recently taken his car to the stealership to have a squeaky clutch pedal fixed which I guess require dash removal.
Since then, randomly the cruise control light will start flashing but there is NO CEL!
The car doesn't feel any different, but have not data logged to verify boost when it happens. The cruise control does not function during the period the car is running with the flashing CC light. Turn off the car for an hour and back on, the cruise control LED is no longer flashing and works as expected.
I also tried forcing a CEL by loosening the gas cap and driving around. This did in fact trigger a CEL so I know the engine diagnostics are functioning properly.
I've since flashed the stock ROM back and am waiting to see if the cruise control flashing without a CEL happens.
I zeroed the OL/CL table to zero in the 3 table cells of the stock downloaded map and ran fine for about a month. The car is 100% stock.
My friend(the owner) had recently taken his car to the stealership to have a squeaky clutch pedal fixed which I guess require dash removal.
Since then, randomly the cruise control light will start flashing but there is NO CEL!
The car doesn't feel any different, but have not data logged to verify boost when it happens. The cruise control does not function during the period the car is running with the flashing CC light. Turn off the car for an hour and back on, the cruise control LED is no longer flashing and works as expected.
I also tried forcing a CEL by loosening the gas cap and driving around. This did in fact trigger a CEL so I know the engine diagnostics are functioning properly.
I've since flashed the stock ROM back and am waiting to see if the cruise control flashing without a CEL happens.
Most likely a problem with your CC system.
Unfortunately, you will need a Subaru Scan Tool to access the fault code in the CC module. Hope this help Matt.
Charlie Yeo
VIP Member
iTrader: (3)
Joined: Nov 2002
Posts: 4,074
From: BAIC Wagon Clique
Car Info: '02 WRB WRX Wagon
It could be a wiring issue. On my wife's and mine '08 Legacy the CC light was flashing. We also had a check engine light, but I had never seen the CC light flash. Turned out to be a problem with the MAP sensor. One of the wires didn't have the proper amount of drag. There could be an issue with the MAF sensor.
Registered User
iTrader: (3)
Joined: Aug 2006
Posts: 1,218
From: milton, fl
Car Info: 2006 San Remo Red WRX
The evap code will sometimes just cause the cruise light to blink and no cel light. Just find out what code is being thrown.
Also, like above. Check and clean your maf sensor
Also, like above. Check and clean your maf sensor
Thread Starter
the artist formerly known as mcdrama
iTrader: (23)
Joined: Apr 2004
Posts: 6,428
From: Santa Cruz Mountains, CA.
Car Info: WRBP 2015 WRX Premium/CVT
Registered User
iTrader: (5)
Joined: Oct 2007
Posts: 1,146
From: San Jose, CA
Car Info: 2006 WRX wagon
I had similar crap happen on my car one time. It was a faulty speed sensor signal that threw off CC light. It ran fine and everything, but that light was on.
I just had to disconnect the battery and re-flash. That fixed it.
I just had to disconnect the battery and re-flash. That fixed it.
Thread Starter
the artist formerly known as mcdrama
iTrader: (23)
Joined: Apr 2004
Posts: 6,428
From: Santa Cruz Mountains, CA.
Car Info: WRBP 2015 WRX Premium/CVT
it hasn't happened for a while. one way to reproduce the same behavior is to hold the CC button in while starting the car. this will cause a flashing cruise control light and disable cruise control.
Thread
Thread Starter
Forum
Replies
Last Post
iGoTsBLu06sTR
Engine Management
6
Jan 21, 2008 06:47 PM
kyle_RS
Suby Shopping & Maintenance/Warranty
4
Jan 7, 2007 04:20 PM
wimprezax06
Engine Management
3
Mar 26, 2006 09:04 PM
digitsti
Engine/Power - EJ25T (STI and 2006+ WRX)
3
Mar 29, 2004 03:40 PM
