Its been 5k miles since I installed the Project Mu 2-piece SCR-Pro slotted & dimpled front rotors, Project Mu SCR 1-piece rear slotted & dimpled rear rotors, Project Mu Titan-KAI Pads front and back, and Project Mu Teflon-covered stainless steel braided brake lines front and back, and I'm very happy with the setup.

I use my STi for daily driving as well as aggressive weekend backroads runs, and these brakes work great.

While they do make a lot of squealing noises, initial stops are decent, and I can't get them to fade, even with a lot of effort.

I used AP racing brake fluid for bleeding when I installed them, and this fluid is superior. Unlike Motul RB600, there are no warnings against using it from Brembo.

I picked it all up from Alex (Imprezer) at BOZZ ( www.bozzperformance.com )

David

 

few questions...

about how much did this setup run, incl install if they took care of that for you too. I'd wouldnt mind taking care of this myself, but next few months i'd rather spend time working or out on the track rather than wrenching on the STi

also what led you to their products instead of stoptech, brembo, ap etc...just price?

 

brakes shouldn't take that long to work on.