leaving member feedback (was: Feedback....help pls)
Thread Starter
VIP Member
iTrader: (22)
Joined: Jul 2006
Posts: 9,546
From: Vacaville
Car Info: 2018 STi
So I was trying to leave feedback for a user, but it says the link was invalid... first of all it kind of sucks that there has to be a link, because we made the deal over PM's but its even lamer that the link was "invalid." Any suggestions?
mods move this if its necessary...
mods move this if its necessary...
is this all part of the new and improved i-club v3?
well from what ive seen on a kicks forum, there was an "agreement" section, where buy and seller would set up a thread posting what transaction was being made and then a mod would i guess verify it? and close the thread and give each person the feedback.
basically if its making you link to a thread, im suggesting make a thread in classifieds(?) stating the transaction. tahts all i can think of.
well from what ive seen on a kicks forum, there was an "agreement" section, where buy and seller would set up a thread posting what transaction was being made and then a mod would i guess verify it? and close the thread and give each person the feedback.
basically if its making you link to a thread, im suggesting make a thread in classifieds(?) stating the transaction. tahts all i can think of.
This Guy Can Hella Draw!
iTrader: (9)
Joined: Nov 2002
Posts: 3,314
From: BAIC Wagon Clique
Car Info: '14 MBP FXT | '03 WW Evo VIII
This the URL I tried.
https://www.i-club.com/forums/norcal-classifieds-96/fs-2003-wrx-front-seats-160411/
Senior Member
Joined: Nov 2004
Posts: 453
From: CA & MD
Car Info: Proj STI, Evo, JDM 180sx Time Attack, & A3
But what if we want to put the URL? I put one in and it says it's invalid.
This the URL I tried.
https://www.i-club.com/forums/showthread.php?t=160411
This the URL I tried.
https://www.i-club.com/forums/showthread.php?t=160411
Thread
Thread Starter
Forum
Replies
Last Post
SF miami WRX
Bay Area
73
Jun 9, 2003 04:32 PM
pico
Engine/Power - EJ20T (pre-2006 WRX and JDM)
7
May 14, 2003 06:05 PM




