Need Help-Advice
#1
Need Help-Advice
I have a 03 WRX with
17-7.5 BR with 234/45/17 YOks.
Carbotech front rotors,
Tein springs
Cucso front strut bar
Perrin up/Down Pipe
HKS hiper Ex
K/N drop in
HKS SSBOV
MBC
I have looked at the different classes and have a hard time figuring out exactly which one I would fit into. I realize I should of started out stock then moded but that did not happpen. The car is somewhat modded and either I continue to mod or figure something else out. I would want to install a cusco 22 mm rear sway bar, carbotech front bake pads, endlinks and rear strut bar. But since I dont really know what class I would be in, I do not know what to use parts that would just put me over the edge and into another class. I am new to this so any help would be very useful. Thank you in advance.
17-7.5 BR with 234/45/17 YOks.
Carbotech front rotors,
Tein springs
Cucso front strut bar
Perrin up/Down Pipe
HKS hiper Ex
K/N drop in
HKS SSBOV
MBC
I have looked at the different classes and have a hard time figuring out exactly which one I would fit into. I realize I should of started out stock then moded but that did not happpen. The car is somewhat modded and either I continue to mod or figure something else out. I would want to install a cusco 22 mm rear sway bar, carbotech front bake pads, endlinks and rear strut bar. But since I dont really know what class I would be in, I do not know what to use parts that would just put me over the edge and into another class. I am new to this so any help would be very useful. Thank you in advance.
Last edited by SPOOLN; 06-29-2004 at 08:31 AM.
#2
Registered User
iTrader: (3)
Join Date: Nov 2002
Location: www.nasioc.com
Posts: 512
Car Info: 2003 STX Pro-Solo/Solo-II National Champion
For SCCA auto-x classing, right now BOV and MBC throw you into SM (and also if you're catless).
Add a cat, remove the MBC and replace the BOV with the stock unit and you can run STX.
Those 4 things are legal in both STX and SM.
--kC
Add a cat, remove the MBC and replace the BOV with the stock unit and you can run STX.
cusco 22 mm rear sway bar, carbotech front bake pads, endlinks and rear strut bar.
--kC
Thread
Thread Starter
Forum
Replies
Last Post
Slack
Sacramento & Reno
2
04-18-2005 04:29 PM
drew888
Engine Management
1
02-04-2003 05:10 AM