Fridays, 9PM COCO meet.
Registered User
Joined: Mar 2008
Posts: 999
From: 925 CO/PH/WC
Car Info: 05 cgm imp
hey so we might be stopping by at 11 but unfortunately only in my car...
buddy got down from oregon last night...we decide to have a friendly competition up taylor since he is bone stock with an APstage1 and im all stocky...rolling start, 3 honk, dead even thru 1st, go to bang 2nd and BLAMMO
one toasted 02 transmission...towed it to a shop bout an hr ago and wont be done for a week! **** sucks hella bad but thats the 02 trans for ya.
still doin mine and brians exhaust today but my homie will be in the passenger seat
buddy got down from oregon last night...we decide to have a friendly competition up taylor since he is bone stock with an APstage1 and im all stocky...rolling start, 3 honk, dead even thru 1st, go to bang 2nd and BLAMMO
one toasted 02 transmission...towed it to a shop bout an hr ago and wont be done for a week! **** sucks hella bad but thats the 02 trans for ya. still doin mine and brians exhaust today but my homie will be in the passenger seat
Registered User
iTrader: (12)
Joined: Apr 2008
Posts: 7,225
From: SF Bay Area - Peninsula
Car Info: 04 psm wrx sedan
well went to brendans today and his exhaust ran into clearance issues because the stock dp is a little too high to mount up to his exhaust and he doesnt want to run catless dp on his so we only got mine on. you'll hear it tmrw night whatever time it ends up being...i can be there whenever but in the mean time here are pictures
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
he should be able to adjust his dp lower at the mid pipe, and or, the cbe can be lifted higher...
when i put mine on i have to lift the cbe to the dp...
when i put mine on i have to lift the cbe to the dp...
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
well... i can install it for u at the meet!
so ya... i know it will go onto the stock dp.. and aftermarket dp doesn't sit any lower than a stock dp...
so ya... i know it will go onto the stock dp.. and aftermarket dp doesn't sit any lower than a stock dp...
Registered User
iTrader: (12)
Joined: Apr 2008
Posts: 7,225
From: SF Bay Area - Peninsula
Car Info: 04 psm wrx sedan
it was hittin the driveshaft braces or whatever. plus its an ebay setup so it might actually sit lower. when exhaust is in hangers and all that it is about half inch to inch off where the dp is
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
hmm...
u know the mid pipe can be moved around a lil.. there is a bolt the goes dp to tranny, and a bolt that goes midpipe to metal hanger to tranny.. lossen those and it will help... but im sure it will fit...
u know the mid pipe can be moved around a lil.. there is a bolt the goes dp to tranny, and a bolt that goes midpipe to metal hanger to tranny.. lossen those and it will help... but im sure it will fit...
