What are these gauges and mounts again?

http://www.importtuner.com/features/0301it_wrx/

What gauges do you need anyways? Are the others aside from boost useful?

 

Boost and EGT are the the usual suspects.

Sorry, I can't help you with the Blitz gauges, but I thought you may be interested in this gauge pod.

http://mastrowrx.com/

 

Wierd, So in the air vent? Hah. I like the pillar mounts tho, but I think the import tuner is a bit on the expensive side, but I want to check it out.

 

boost, egt, oil pressure, fuel pressure, ..... oil & water temps, ... air/fuel - even though most air/fuel gauges aren't very accurate for tunning.

speedgear has the blitz gauges - more expensive than if you ordered them though

 

SpeedGear had a nice 2 gauge pillar mount, but so small nothing Blitz would fit into it. I was thinking mainly boost and if I had to fill a 2 or 3 mount I would get egt and maybe oil pressure.

Anyone know of a nice 2-3 pillar mount at all? Something that would fit either the 52 or 60 Blitz gauges?

Yeah they are expensive! Ouch. Didnt see much there at all really and didn get a whole lot of information. Sorta felt like I was asking the wrong questions or they werent interested in looking stuff up. Oh well. Probably thought I was some stupid haole just asking questions.

 

Boost and EGT are a requirement... It's the gauges after that that are hard to decide on. I went with oil pressure, but if I could do it over again, I would also have oil temp, water temp, and fuel pressure as well. So that would mean some $1800 in gauges alone

But as for a A-pillar pod you could get a lo-tek pod in either 2 or 3 pod model and either 52mm or 60mm versions too.
http://www.gaugepods.com/wrx.htm

 

autometer has a 2 or 3 A-pillar gauge pod, 52mm (2 1/16") holes, but can be carefully dremelled to fit 60mm gauges also. That's what a few guys use (used), with Autometer Gauges

If you're planning on modding your car, the Boost, EGT, and oil pressure are good gauges to start with, ... and dare I say, almost a must.

 

Say NO to low-tek!!!!

they suck, ask 18hr!

 

Cool, ordered the 3 gauge and will try some 60mm Blitz DC gauges. Tho I want a boost gauge with PSI not bar. Hmm...

 

OH NOW YOU TELL ME! Hah, after I clicked order. Oh well, only fitty dollarz...

 

cancel the order!!!!!
they have even come close to shipping it anyway, trust me!

 

Yep, already had. =)

So now that I still dont know a source for 60mm gauge pods any suggestions? Still trying to find out what the Silver Import Tuner had that just stuck to the window...

http://www.importtuner.com/features/0301it_wrx/

 

I know that this is a late post, but:



PSI^3 S.E.C.S. Monitor Unit Type 4 (Pod Mount) - WRX $520.00

 

Lookin for the a-pillar mounts, I like the look. Will probably relocate the radio to the clock and then do something like video in the stock radio slot. Just future plans really, but do need a good 3-gauge 60mm pillar mount... Grr... Been looking all day...

 

http://forums.nasioc.com/forums/show...t=import+tuner