exhaust question
#1
Registered User
Thread Starter
Join Date: Sep 2009
Location: jersey
Posts: 3
Car Info: 03 subaru wrs
exhaust question
I just put on an N1 catback exhaust with uppipe and downpipe. However I am having a problem with the conection between the uppipe and the existing OEM catpipe that runs from the manifold. The OEM catpipe is a 2" pipe and my new uppipe is a 3" pipe so my gasket between the two keeps burning up after about a week. Is there anything to do other then changing out the uppipe? Any help would be greatly appreciated. Thanks.
#3
Registered User
Thread Starter
Join Date: Sep 2009
Location: jersey
Posts: 3
Car Info: 03 subaru wrs
no its def the uppipe. first exhaust ive done, but the downpipe comes out to the back to the midpipe to the muf. i have a problem with the uppipe going into the turbo. the pipe that feeds to the uppipe is smaller then the uppipe so that gasket keeps blowing.
#4
Registered User
iTrader: (2)
Join Date: Dec 2003
Location: Danville, CA
Posts: 258
Car Info: Audi Q5 aka "the old man wagon"
ditch the uppipe and just use the stock one.
Otherwise ur best bet would be to run down to a muffler shop and have em weld on a section of pipe that tapers down with a new flange, but that'll cost you $50 or so
Otherwise ur best bet would be to run down to a muffler shop and have em weld on a section of pipe that tapers down with a new flange, but that'll cost you $50 or so
Thread
Thread Starter
Forum
Replies
Last Post
brucelee
Bay Area
12
08-01-2009 10:59 AM
Skatemur
Engine/Power - EJ20T (pre-2006 WRX and JDM)
12
10-01-2004 12:56 PM
dj_kiyoshi
Engine/Power - EJ20T (pre-2006 WRX and JDM)
15
07-24-2004 12:36 AM
2K3WRX808
Engine/Power - EJ20T (pre-2006 WRX and JDM)
10
06-28-2004 01:40 PM
legacy2003
Interior, Exterior & Lighting
6
06-08-2003 04:43 AM