Ok so here is what went down. Swapped my stock turbo out for a rotated 3076 turbo.



Pulled the intake manifold with all the clips ext. cleaned the gaskets off and put new ones on. While the car was apart i put new ngk one step colder plugs in. new oil and coolant. got everything bolted up last night re plugged in the fuel pump, and flashed the limp/base map to the car. Went to start the car, turns over but no fire... I’m kind of at a loss where to start any ideas would be great!



here are mods



2005 STi
with Cobb AccessPORT V1

3076 turbo with .82 a/r housing
3" down pipe
perrin rotated up pipe.
44mm wg
perrin big maf intake filter

perrin fmic with perrin blow through boost tube with an hks bov weld to it before map

hks Ti carbon 3" exhaust

850 pe injectors.

ngk one step colder plugs

 

when you flashed the base map did you remember to unplugged the green connector under the dash?