exhaust, many problems
#1
Guest
Posts: n/a
exhaust, many problems
I went to install my exhaust today, and ran into some crazy problems lol. I put in the BPM downpipe, then tried putting in an HKS carbon fiber cat back kit. Well, the downpipe and cat back exhaust did not fit. there was a 6 inch difference between the mid pipe and downpipe. anyone run into this problem? I sent back the BPM downpipe, and ordered the HKS downpipe. I am guessing the BPM is designed to be used with their own exhaust system. I wasn't very happy today lol.
Also I am putting in the O2 eliminator kit, has anyone put this one in yet? the wiring digram in the instructions suck and make no sense. any help would be appreciated.
Also I am putting in the O2 eliminator kit, has anyone put this one in yet? the wiring digram in the instructions suck and make no sense. any help would be appreciated.
#2
Guest
Posts: n/a
hahaha, u need to do more reserch b4 u do ur mods
the U.S. spec wrx has 3 cats, and the jdm sti only has 2. so the size of the down pipe and middle pipe of the U.S. verson is different from the ddm ones, so u kindda have to get the jdm front, middle and rear pipe, and that would get rid of the extra cat. but ofcourse this would not allow u to pass somg, so u better skeep ur stock pipe
the U.S. spec wrx has 3 cats, and the jdm sti only has 2. so the size of the down pipe and middle pipe of the U.S. verson is different from the ddm ones, so u kindda have to get the jdm front, middle and rear pipe, and that would get rid of the extra cat. but ofcourse this would not allow u to pass somg, so u better skeep ur stock pipe
Thread
Thread Starter
Forum
Replies
Last Post
grex767
Engine/Power - EJ20T (pre-2006 WRX and JDM)
6
05-27-2006 10:37 AM
silver_rex_4eat
Subaru General
2
03-09-2003 01:07 PM