Confusing oil pressure readings
Guest
Posts: n/a
Confusing oil pressure readings
I just had a autometer carbon series electrical oil pressure gauge. The guy who installed it told me that the oil pressure should be between 30 to 50 psi. However the oil pressure goes upto 95 psi when I start the car and stays there for sometime. After a while it drops down to 45 psi. When I rev the gas, it goes up again.
Does this make sense to anybody ?
Does this make sense to anybody ?
Registered User
iTrader: (1)
Joined: Nov 2002
Posts: 251
From: SF Bay Area
Car Info: 2005 Subaru STI
Admin v2.0
iTrader: (9)
Joined: Nov 2002
Posts: 6,965
From: Alameda, CA, USA
Car Info: 02 Black Legacy GT
Yeah, normal.
Remember, your oilpump is connected to your crank, so with RPM's, the pressure goes up. That, and the temp of the oil also affects the pressure.
- Alex
Remember, your oilpump is connected to your crank, so with RPM's, the pressure goes up. That, and the temp of the oil also affects the pressure.
- Alex
Guest
Posts: n/a
Oil pressure will always be high on startup, especially when the motor is cold, since the viscosity of the oil is thick. When it warms up, it'll go down. If you're a real warm-up ****, you'll wait until your oil pressure drops before you even drive the car.
Larry
Larry
Pr0n King
iTrader: (3)
Joined: Nov 2002
Posts: 26,618
From: The Land of Rocks
Car Info: Turncoat Turbo
Sounds like normal operating specs to me.
<teasing tone> What were you expecting to see? </teasing tone>
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
<teasing tone> What were you expecting to see? </teasing tone>
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Thread
Thread Starter
Forum
Replies
Last Post
06ezSTI
New Aftermarket Car Parts For Sale
2
Apr 22, 2008 08:00 PM
suby_dude
NorCal Classifieds
4
Feb 12, 2008 01:28 PM
JackHCChen
Engine/Power - EJ20T (pre-2006 WRX and JDM)
5
Nov 12, 2005 09:50 PM
