Clutch Problem ???
Thread Starter
Registered User
Joined: Jun 2004
Posts: 88
From: St. Kitts island in the Caribbean
Car Info: Subaru JDM Type RA
Clutch Problem ???
OK i rebuilt my tranny and put it baq in now i find that i cant make any gears once the car is started....wen i start it in neutral and try to put it in 1st it doesn go no matter how i pump the clutch.....and if i start it in 1st with the clutch in it'll roll forward slowly...if it is off i can select each gear including reverse easily
i have a twin disc exedy clutch kit with flywheel installed...never experienced this problem b4 cuz it be my pressure plate has gorn bad ? it isnt releasin the clutch disc far enough to stop the gears from spinnin for ez selection ?
i have a twin disc exedy clutch kit with flywheel installed...never experienced this problem b4 cuz it be my pressure plate has gorn bad ? it isnt releasin the clutch disc far enough to stop the gears from spinnin for ez selection ?
Registered User
iTrader: (6)
Joined: Jan 2010
Posts: 324
From: Crestview Fl
Car Info: 04' wrb WRX sedan
You may have put the clutch disk in backwards?! We did it on the first clutch my brother and I swapped on a honda with a six puck. We were in a hurry and weren't paying attention.
iClub Silver Vendor
iTrader: (12)
Joined: Mar 2003
Posts: 8,228
From: 631 Railroad Ave. Fairfield, CA
Car Info: A Laptop
The disc is dragging on the pressure plate. Either you installed the disc incorrectly, or its damaged. You'll have to pull it back apart and inspect everything very closely.
-- Ed
-- Ed
Thread
Thread Starter
Forum
Replies
Last Post
cruzinWRX
Drivetrain
1
Jan 16, 2005 06:42 AM



