Ecutek and External Sensor Logging
Ecutek and External Sensor Logging
Ecutek has a new feature that allows the use of a LabJack U12 unit to use a Wide Band 02 for logging. Anyone do this yet? If so, what do I need exactly to monitor and log A/F ratios.
Russell
Russell
Guest
Posts: n/a
I bought the delta dash and have a LabJack connected. I am only logging pressures and temperatures right now, and will most likey add a wideband at a later time. I have a laptop in the car with the labjack and just pulling all the sensors to the labjack unit. I do need a signal converter for the thermocouples to get a 10 volt signal, just trying to work the bugs out of that so I can read below 100 degrees.
Hooking up a wideband should be simple, just connect the O2 to power and run a ground wire and the O2 signal wire to the LabJack. The DeltaDash software will be able to read the signal from the O2 and log it with whatever else you want.
Hooking up a wideband should be simple, just connect the O2 to power and run a ground wire and the O2 signal wire to the LabJack. The DeltaDash software will be able to read the signal from the O2 and log it with whatever else you want.
Thread
Thread Starter
Forum
Replies
Last Post
DomozitoLK
NorCal Classifieds
0
Jul 7, 2010 09:38 AM