Hey I'm replacing my clutch and was wondering if this flywheel could be resurfaced. Does it look shot?

 

Resurfacing is cheap, usually $30-45. so take it wherever you would take it and see what they say. Good luck, I hope it is still salvagable.

 

Do you see the discolorization that from heat warping... this is bad. Also the obvious cracks this is also bad. I would just replace is.... unless yu dont mind pulling it off again in another 3k.

 

It's time for a new one.

 

just replace it...it's not worth the trouble

 

Previous owner's wife rode the clutch a lot... he says she was scared of driving it or something stupid I was half sure it would be messed up when I pulled it. The disc was worn to the rivets!

My mechanic friend that works on semi trucks says the cracks are fine and that it'd be bad only if it was too thin to machine. But that's a huge desiel not a subaru so I'm askin you guys

I'm leanin toward a nice ACT street-lite

 

Your flywheel is toast. Needs replacing.