Local place to roll a bead on a 2" pipe?
Thread Starter
Registered User
iTrader: (2)
Joined: Nov 2009
Posts: 369
From: Dublin, CA
Car Info: 02 WRX sedan
Local place to roll a bead on a 2" pipe?
Looking for a place (pref in San Leandro to San Jose strip of East / South Bay) I can walk in and ask to roll a bead on a short 2" pipe and walk out 10-30 minutes later a $20 or two lighter with it done.
I need only one end of the pipe bead rolled.
Anyone know of such a place?
I need only one end of the pipe bead rolled.
Anyone know of such a place?
Registered User
iTrader: (57)
Joined: Aug 2006
Posts: 7,380
From: the area
Car Info: 04 impreza wrx R.I.P Daniel Wentz JOEBOBBUCKET
034 motorsports in fremont does bead rolling. I had them roll my FMIC pipes 2.75 inch and 3 inch pipings. I think they charged me like 25 dollarsor something like that
Thread Starter
Registered User
iTrader: (2)
Joined: Nov 2009
Posts: 369
From: Dublin, CA
Car Info: 02 WRX sedan
Mike --
2" diameter aluminum
Length is about 2.25 to 2.5"
It came 3" long rolled both sides, but it needed to be shorter than 3". Cut off one bead and I have to re-seat it every month or two even if I crank down on the Zebra clamps.
2" diameter aluminum
Length is about 2.25 to 2.5"
It came 3" long rolled both sides, but it needed to be shorter than 3". Cut off one bead and I have to re-seat it every month or two even if I crank down on the Zebra clamps.
Last edited by Concillian; Jan 15, 2014 at 05:56 PM.
Registered User
Joined: Jul 2013
Posts: 325
From: Hayward
Car Info: 1996 Impreza L
Pretty certain I can do that, bring it by
Thread
Thread Starter
Forum
Replies
Last Post
mystilexzero
NorCal Classifieds
7
Feb 28, 2012 11:54 PM