is this illegal
Thread Starter
VIP Member
iTrader: (14)
Joined: May 2003
Posts: 8,675
From: Wherever Sucks the Most
Car Info: 2003 WRX, 2008 Camry
Originally posted by Sisqocqk
Hey Freddie,
How did you install it... just so i know when i comes in the mail???
maybe you could post some pics. that would be appreciated
eric
Hey Freddie,
How did you install it... just so i know when i comes in the mail???
maybe you could post some pics. that would be appreciated
eric
Hmmm??? eric
Registered User
iTrader: (15)
Joined: Nov 2002
Posts: 4,962
From: watching you get smaller...in my rear-view
Car Info: 02 STi
Originally posted by Sisqocqk
Hey Freddie,
How did you install it... just so i know when i comes in the mail???
maybe you could post some pics. that would be appreciated
eric
Hey Freddie,
How did you install it... just so i know when i comes in the mail???
maybe you could post some pics. that would be appreciated
eric
I'll try to get up some pics for you
-freddie
Thread Starter
VIP Member
iTrader: (14)
Joined: May 2003
Posts: 8,675
From: Wherever Sucks the Most
Car Info: 2003 WRX, 2008 Camry
Originally posted by 1WRX2NV
ok. no problem. It was easy just use the tape that should come with it. if not you can get double tape from OSH. You might have to rtim the hole for the guage a little so it will be a snug fit.
I'll try to get up some pics for you
-freddie
ok. no problem. It was easy just use the tape that should come with it. if not you can get double tape from OSH. You might have to rtim the hole for the guage a little so it will be a snug fit.
I'll try to get up some pics for you
-freddie
also, where did you route the wires/ tubing. i've never installed a boost gauge so.....
Last edited by Salty; Jun 2, 2003 at 02:49 PM.
Registered User
Joined: Nov 2002
Posts: 1,402
From: Bay Area
Car Info: 02 WRX wagon=dead; rollin' in a Craptastic Camry!
Originally posted by BAN SUVS
She does too have a personality over there! It's "hateful self-righteous ****."
She does too have a personality over there! It's "hateful self-righteous ****."
No, he did not just post that!
Registered User
iTrader: (15)
Joined: Nov 2002
Posts: 4,962
From: watching you get smaller...in my rear-view
Car Info: 02 STi
Originally posted by Sisqocqk
cool beans. thanks, eric.
also, where did you route the wires/ tubing. i've never installed a boost gauge so.....
cool beans. thanks, eric.
also, where did you route the wires/ tubing. i've never installed a boost gauge so.....
Oh, you can wire the gauge light to the fuse that goes to the interior lighting. Pull out the fuse...put the wire accross the fuse opening...push the fuse back in. Walla.
-freddie
Thread Starter
VIP Member
iTrader: (14)
Joined: May 2003
Posts: 8,675
From: Wherever Sucks the Most
Car Info: 2003 WRX, 2008 Camry
Originally posted by 1WRX2NV
I think that underneath the dash (driver side) there is a gromet that goes to the engine compartment. Poke a small hole there and feed the vaccum hose through. Then for the inside "floss" the vaccum hose between the dash and the "A" pillar. Then run it through the pod, conect to the gauge and fit the gauge into the pod. Then tape the pod to the dash and "A" Pillar. DONE!!!!
Oh, you can wire the gauge light to the fuse that goes to the interior lighting. Pull out the fuse...put the wire accross the fuse opening...push the fuse back in. Walla.
-freddie
I think that underneath the dash (driver side) there is a gromet that goes to the engine compartment. Poke a small hole there and feed the vaccum hose through. Then for the inside "floss" the vaccum hose between the dash and the "A" pillar. Then run it through the pod, conect to the gauge and fit the gauge into the pod. Then tape the pod to the dash and "A" Pillar. DONE!!!!
Oh, you can wire the gauge light to the fuse that goes to the interior lighting. Pull out the fuse...put the wire accross the fuse opening...push the fuse back in. Walla.
-freddie
Once again, i appreciate it a lot freddie. once everything is said and done i'll take some pictures. thanks, eric
Registered User
Joined: May 2003
Posts: 258
From: leggtnut on legacygt.com
Car Info: 2006 BSP LGT / 2004 JBP FXT
I have seen the guage that you are talking about. It looks really sharp. I know that http://www.rallitek.com sells it for the forester and all impreza's. They are working on getting the company to get them to sell them for the Baja (the dash has a different contour to it).
http://www.rallitek.com/products.asp...&HB=&ACC=Y&SP=
http://www.rallitek.com/products.asp...&HB=&ACC=Y&SP=
Last edited by BajaNut; Jun 29, 2004 at 10:14 PM.
