I'm not sure if you guys know about this product, but here you go

http://www.nipponpower.com/engine/ma...ar_gasket.html

Andy

 

sure it should work, but then again, I dont see anything special about that gasket as opposed to any other rubber reinforced gaskets that you can get at your local Kragen's for probably alot less $. Plus for the amount of work that it would take to install....would hardly be worth it unless you already have the engine apart for other reasons.

-Ted

 

Agreed

 

Given the following illustrations, I'm convinced.





I'M CONVINCED!!!

 

Well, when yo put it THAT way...

-Chris

 

probably just a phelonic spacer like they used to use between carbs/intake manifolds to keep the heat from the engine heating up the carbs, that was more to keep the fuel from getting to warm and vaporizing, this doesnt seem like it would be a big issue on FI cars though

 

i am sure it helps, but how much, i am not sure, and is it worth it, i can think of much better ways to spend my money

 

i believe hondata has a gasket that works the same way for the RSX typ-s intake mani.

 

Man, that ish sucks. Get some ITB's and forget about it.