Can anyone point me to a good how-to for a wrx header install??

Can this be done in my garage without a lift?

 

Maybe theres one on www.scoobymods.com

 

As long as you got a set or ramps, it's very easy. Should take about an hour if you take your time. Just make sure to note how all the bolts got and which way the gaskets are pointed. You may also want to spray the heat shield bolts with some penetrating fluid prior to starting the work and make sure you wear some eye protection while under there. Air tools make the whole job much easier.

Alex...

 

Is it hard to do for someone who hasn't had much experience with cars? Do you need to remove any parts to remove the header?

 

u have to remove to 02 sensor and unbolt the up pipe where it bolts to the header other than that take the heat shields off both side and 3 bolts perside pretty easy took me about 40 mins after a beer or two

 

but drink the beer after you install not before if you do then you will end up installing the headers on your roof or something.hahaha