Question about installing hks coilovers?
Guest
Posts: n/a
Question about installing hks coilovers?
I bought a set of hks hipermaxII used. My question about installing is the adj at the top of the coilover for camber/caster. The pillow mount can swivel which may should it mount? Where the adj goes side to side or front to back or diagonal? Any advice would be great. Also what is the best way adj for ride heigth and dampening to make sure everthing is even from frt to back side to side.
2006 Mt Hammy Car Show Winner
iTrader: (11)
Joined: Dec 2002
Posts: 2,730
From: Danville, CA
Car Info: Black 03 WRX, White 04 E46 M3
when installing the coilovers the HKS emblem should be on the outside of the car, this way the camber can be adjusted from side to side. All dampening adjustments are done on the bottum of the coilover with the purple ****. I am running 21 from full soft in the rear and 20 from full soft in the front. I find this to be a good setup for street. For ride height just put them next to the stock struts when adjusting them and go from there, it isn't too hard and when you go for an allignment have them fine tune it.
Thread
Thread Starter
Forum
Replies
Last Post
ZtotheH
Suspension, Handling, and Brakes
1
Jan 8, 2010 03:14 PM
markymark77
Engine/Power - EJ20T (pre-2006 WRX and JDM)
0
Jan 28, 2004 08:33 PM
aviarome
Engine/Power - EJ20T (pre-2006 WRX and JDM)
1
Feb 1, 2003 09:30 PM
genmaster
Engine/Power - EJ20T (pre-2006 WRX and JDM)
4
Jan 11, 2003 12:22 AM
