I've been very happy thus far with my Zero2R running 7k front 8k rear springs. I also have a set of Cusco rear camber plates (p/n 658-420-A) which I ran on my previous coilover setup. The Zero2R that I have came with the rigid rubber top mounts in the rear.
To put these two together, I figure I'll need the correct upper spring perches (65 mm ID) and possibly the correct spacers/collars since the camber kit came with a threaded collar meant for the stock strut. Does anyone know what I'm referring to and know what the p/n's are? Estimated cost?

 

Alex?

 

You shouldn't need anything. Just an aditional spacer washer. The upper spring seat is already there with the rigid rubber mounts. All you need now is to figure out how thick the spacer you need. You can come down with the parts and I will figure it out for you.

 

Alex

With the current setup, the spring seats directly on the rigid rubber upper mount. See generic picture attached. The camber plate will be replacing this rigid rubber mount, and thus, an upper spring perch will be needed. I just need to figure out which spacer(s) and/or additional h/w I need.

 

Alex

Sent you PM.

 

Got it. Ordered it. Should be here in a bit.

 

Alex, can you PM me the pricings? Thanks.