MAS plugged in or not?
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Dec 2002
Location: Longmont, Colo.
Posts: 187
Car Info: Black WRX, X.S. turbo back exhaust, X.S. cold air, and a lot of plans
MAS plugged in or not?
What would happen if I run my car without the MAS? I just put on MRT fuel rails and sti injectes and a surpa pump, and my car runs very bad with the MAS pluged in, like doesn't run for more then a min. then dies. When I unplug the MAS it runs great, I have an air/fuel gauge which is reading within good running levels. My question is will I hurt anything by driving with the MAS unplugged? I have a Link ECU coming so it only for a few days ( I hope).
ThankS for you help.
MCL
ThankS for you help.
MCL
#2
Registered User
Thread Starter
iTrader: (1)
Join Date: Dec 2002
Location: Longmont, Colo.
Posts: 187
Car Info: Black WRX, X.S. turbo back exhaust, X.S. cold air, and a lot of plans
Nevermind I jut drove it up the block and it's not running right at all. It idles ok, revs ok, but when you try to go it's not ok.
If a Moderator reads this can you delete the whole post.
ThankS again
If a Moderator reads this can you delete the whole post.
ThankS again
Thread
Thread Starter
Forum
Replies
Last Post
Clarkkent
Engine/Power - EJ20T (pre-2006 WRX and JDM)
7
08-13-2003 08:42 PM