Hey everyone,

I need a bung welded onto my stock manifold so I can install my EGT sensor. Do you guys have any recommendations for exhaust shops in Sacramento who can do this properly and know where the sensor should be mounted?

Thanks!

 

if its stock manifold like you said it doesnt get welded. Just drill it and tap it. from memory for a 1/8" npt tap you want to use an 11/32" drill bit followed by the 1/8" npt tap. Driver side manifold theres a nice flat spot on which is perfect for placing the egt sensor.

 

Nice! Thank you very much for the tip!