Paintless Dent Removal
#1
Paintless Dent Removal
Does anyone know of a good paintless dent removal place in the Denver area? I have a dent in my driver's side quarter panel and I don't like it. Any suggestions? Thanks, Jeremy
#3
The only Paintless Dent Repair I know of is off Hampden and I-25 just east of I-25 on Hampden, I have never had work done by them but they do have alot of cars comeing and going, Its a Yellow building cant miss it.
As for the Dry Ice idea, never done it but when we were little kids we use to use Dry Ice to blow up trash cans...
Take a couple of peices put them into a 2-liter bottle fill it half full with water and put the cap on. the pressure builds and builds then it explodes. Now NOTE I said when we were little so that means when we were DUMB kids...haha
Well thats about as helpful as I can be at the moment. sorry for the lack of knowledge on paintless dent repair..good luck.
As for the Dry Ice idea, never done it but when we were little kids we use to use Dry Ice to blow up trash cans...
Take a couple of peices put them into a 2-liter bottle fill it half full with water and put the cap on. the pressure builds and builds then it explodes. Now NOTE I said when we were little so that means when we were DUMB kids...haha
Well thats about as helpful as I can be at the moment. sorry for the lack of knowledge on paintless dent repair..good luck.
#5
Guest
Posts: n/a
Originally posted by SubeTek
I've got a guy here in Boulder-he's very good. Let me know.
Bret
I've got a guy here in Boulder-he's very good. Let me know.
Bret
Thanks,
Charlie
#7
Hey everyone, I'm back in Colorado after two years in El Paso. I need someone who can fix door dings and small dents. Does anyone know anybody? I'm looking at paintless since I have a good airbrush and wont have any trouble touching up the scratches after the dent is fixed. Thanks guys, and I'll check back in a few months once someone actually remembers this forum exsists, haha.
Thread
Thread Starter
Forum
Replies
Last Post
DetailAddict
NorCal Classifieds
40
05-03-2007 03:08 PM