FS: Race Ramps, Axle Backs and alumilite
#1
Registered User
Thread Starter
iTrader: (3)
Join Date: May 2009
Location: Vacaville, CA
Posts: 249
Car Info: 2015 ISM STI Limited
FS: Race Ramps, Axle Backs and alumilite
Name: Daniel
Location: Travis AFB/Vacaville Ca
Contact: PM
Prices: Race Ramps $200 / Axle backs $220 / alumilite $60
POSSIBLE TRADES: i am looking for a 2015+ invidia N1 single exit or Tomei Expreme catback, i have an invidia Q300 in great condition and willing to make a combo deal if interested.
These items are all pick up only, axle backs i might be willing to ship at buyers expense.
Descriptions:
Race Ramps are 67" total length and 14" wide. These are a 2 piece design and very light! these are great for track days and loading up in the car but weigh less than a few pounds each! great ramps get em while they last!
Axle Backs are P and L 3" piping and 3.5" burnt tips... i was originally going to fabricate these to fit an invidia mid/Y pipe but ended up going a different route.
Alumilite left overs from a front splitter project i did... theres plenty of board left for anyones projects they may want to do... i was going to make a rear diffuser with the leftovers but ended up going a different route... my loss is your gain! pictures below of what you can make with this stuff. its two thin sheets of aluminum sheet metal with a hardened foam board in the middle.
Location: Travis AFB/Vacaville Ca
Contact: PM
Prices: Race Ramps $200 / Axle backs $220 / alumilite $60
POSSIBLE TRADES: i am looking for a 2015+ invidia N1 single exit or Tomei Expreme catback, i have an invidia Q300 in great condition and willing to make a combo deal if interested.
These items are all pick up only, axle backs i might be willing to ship at buyers expense.
Descriptions:
Race Ramps are 67" total length and 14" wide. These are a 2 piece design and very light! these are great for track days and loading up in the car but weigh less than a few pounds each! great ramps get em while they last!
Axle Backs are P and L 3" piping and 3.5" burnt tips... i was originally going to fabricate these to fit an invidia mid/Y pipe but ended up going a different route.
Alumilite left overs from a front splitter project i did... theres plenty of board left for anyones projects they may want to do... i was going to make a rear diffuser with the leftovers but ended up going a different route... my loss is your gain! pictures below of what you can make with this stuff. its two thin sheets of aluminum sheet metal with a hardened foam board in the middle.
Thread
Thread Starter
Forum
Replies
Last Post
ddavis
NorCal Classifieds
6
05-27-2013 06:18 PM
SubySal
Engine/Power - non turbo (All non turbo Imprezas)
5
01-16-2004 02:29 PM