I purchased the exedy twin plate used from a local member last year with 8,000 miles on it. My car has a jdm 6 speed swapped in and I ran the clutch on my car for a couple thousand miles. Recently the clutch made more noise than usual and so I removed it from the car and replaced it with another clutch. Upon inspecting it the rear disk was not engaging properly. I sent it back to Exedy and they determined that there was a misallignment on the install and this caused the damage. The clutch is currently at Exedy and is going to be rebuilt with the following new parts

New pressure plate and complete bolt kit for clutch
Two brand new clutch disks
New pilot bearing

They have already confirmed that the flywheel is in good condition and all other surfaces are in great condition. So this clutch will basically be brand new once it is back from Exedy as the parts that would normally wear down are all going to be brand new.

I am looking to get $1000 picked up for the clutch (this clutch retails for $1750+)

PM me if you have any questions about the clutch.

 

this clutch is by far the most fun and gnarly mod you can do for your car. and thats coming from someone with a complete sti shortblock, 6 speed and drivetrain swap, with a 20g and suspension mods to make my wagon handle like its on rails.

its hard to explain how awesome this clutch is.

good luck selling

-jon

 

PM'd you