I did a little bit of a port job, but not much was needed at all. I had intake manifold gaskets so that they were matched to the port job. I didnt take off more than the gasket covered.

SOLD

Here's some pics that are scaled down.
(Yes, that's my kitchen table, please ignore the junk on it. I have some very creative friends )








I did a full thread and took some pics during this project. They can all be viewed here: https://www.i-club.com/forums/central-valley-210/intake-manifold-fun-lots-o-pics-179304/


This part has been in storage just down the road from me for the last couple months so before I accept any money I'm going to make sure it hasn't been damaged at all during the moving process. But offers will be accepted in order they're recieved.

Thanks!

 

Up for the evening.

 

I dunno if it's just me...but your pics are borked in the link. Overall in the pic in this thread...looks like you did a damn good job painting it

 

The pics in the link are loading, they're in my pb. The pics in the other thread are pretty big though, and they're a lot of them so they may take a lil while to load... Anyone else have a problem seeing them?

Thanks btw, I took my time (a couple 12hr shifts at work) and clean/blasted/port/polished it all.

 

pics load fine for me. that's a kick *** job man.

 

bumpage

 

Bump

 

hey ryan, i might pick this up from you if its still around in a couple months when i actually have money.

 

Ya, just let me know. It's just sitting around here in a storage box.

Bumpage, obo!

 

do mine...haha...

i'm looking to do this.

 

Send it on over. I have 12hrs to kill a night and a ton of tools to do the job. Plus plenty of krinkle black.

 

Up!!!

 

Still for sale, make an offer!

 

bumpage

 

Up! Still for sale.