Hi guys, I bought a hid kit from lightwerkz (lost the instructions, emailed them twice with no reply) and I'm trying to figure out the wiring

The kit came with 2 matsu****a ballasts, 2 h11 bulbs, and one of their custom relay harnesses


Looking at what I have:

https://dl.dropbox.com/u/12397062/20...2021.44.19.jpg
This is the lightwerkz relay, Can What is that middle connector for? Am I supposed to connect that to the original power connector for the headlight?


https://dl.dropbox.com/u/12397062/20...2021.44.52.jpg
And for the bulb itself, what are those unused set of wires? Can I just remove them?


Thanks in advance!

 

As for the wtf is this wire that should plug into your original light bulb harness and the extra wires I wouldnt mess with if they came on the relay like that.. better to keep them on there then take them off and have it screw something up

 

Aye, it's all been sorted out now, thanks

 

Well cool hope they are workin out well and they look good... how much did they cost and where did u get them

 

Bought everything from lightwerkz (except for the projectors, bought them from TRS)

about $450 with taxes and all the parts (relay, ballasts, bulbs, projectors)

 

for prosperity sake, in your first picture, the "WTF is this for?" is supposed to connect to a 9006 type OEM harness plug. In the second picture, the extra set of wires is supposed to be used to integrate into the OEM harness by plugging it into the correct terminal female spade. The other end plugs into the first picture's "WTF is this plug" and provides turn on signal to the ballast.