Just installed injectors, turbo, custom cobb ap map. Won't go past like 2 psi. Idles good and runs ok just won't boost. Suggestions?

 

When you ask for assistance, it's best to spell out what you did...what mods you installed specifically...

What map did you use? Did someone write you a safe map for your mods?

Don't try to drive it without some sort of safe map...


pm me...

 

Samco ancillary hose kit, Deatchwerks 750cc injectors, walbro pump, FP 68HTA turbo and oil feed line, OTS map from PDX.On a side note, when installing the oil feed line; be sure to tighten down the swivel ends of the feed line. Otherwise you get to bathe your engine.

 

check your boost lines to make sure they are all connected and everything is calibrated.

+1 for what the guy above me said

 

Hold on, just read about a boost pill. Just installed the factory lines, boosts to 8 psi now. Guess I have to drill it out with 3/64ths drill bit? Anyone know anything about this?

 

Yeah, just be careful when you're drilling the hole that you have it drilled to the correct size and you'll be good to go...

Look into getting a MBC to help with your boost regulation.

OTS maps tend to run rich so they stay on the safe side. With you're kind of upgrades, it's definitely recommended to get your car dyno tuned so it's fine tuned and you can take advantage of all your upgrades.

 

Mbc.