last night went to get it read by carlo from chris' AP...

code was P0546...

still kinda unsure...but its something about "P0546 Exhaust gas temperature sensor circuit high input "

anyone know and can help???

carlo cleared it off last night...but on my way home from UH side once i get near mililani the CEL light pops on again...it did that a few time also after i reset my ECU...

well...when i leave my window open i do notice a big outside temperature drop when going into mililani...thought that might be a factor....i dunno....

i need help...

*EDIT*
if this helps...here's a list of my mods...

-intake
-helix up-pipe
-helix downpipe
-blitz nur spec cat back
other than that everything is stock

 

...

 

sorry cant help you there..you might wnna go get that code checked up.. by service?

 

might try that myron...but i've been reading (haha...after i put up a post) and i think its just that its time to change out my UP EGT sensor for a bolt to just plug up the hole and put a resistor where the plug was...i think...

 

good to hear you got it worked out....

 

fixing it tomorrow hopefully

 

maybe you're running lean with the intake....

 

...leading to high EGT...could be a possibility...