Has anyone done the wastegate flutter fix where you shorten the actuator arm a few turns? I have the c-clip off but i'm not sure how to disconnect the arm in order to shorten it and I don't want to mess anything up.

Can anyone help please?

Thanks

 

Take the clip out, then uptight the bolt that’s there it was hard I had to put allot of oil on it, then tight the end of the arm.

I did 2 turns because COBB stage 2 Access point didn’t raise my PSI.
And with gate adjustment I get faster spool shows 0 bar at 2000 rpm, and about 15 psi in 3d gear.