i am doing a 2.2l engine build, and need to upgrade my injectors.

i would like to use stock wrx injectors because they are easially avaliable here on the board. does anyone if they will just drop into my stock fuel rails? i could go with stock turbo legacy injectors but would rather pay less for better wrx injectors.

also, i am having trouble pulling my injectors out of the fuel rails, is there a trick to this that i dont know? i think the o-rings are just hardened and making it hard on me...

thanks for any help!

 

should i post in a different fourm? i will probably just get new turbo legacy injectors rather than taking a chance on wrx ones not fitting...

 

i am doing a n/a build, i was just posting here to see if someone knew if the wrx injectors would fit... i am running 11-1 high cr pistons, torque cams, lightened flywheel, ported and polished heads, etc...

i only need enough fuel for the n/a build, so i dont need anything too exotic...

i am basically assuming that the stock injectors wont handle the amount of fuel the engine will need... i plan on an aftermarket engine management system too, after i get the car running.

any suggestions?