i have to re-build my engine cause i pulled a misfire code and i have a lot of oil blow by. i am now looking to build my engine including new: pistons, values/springs, connecting rods, rings, and studs. i want to have a strong motor and i dont know where i can get the parts. any help, anyone?

 

sometimes u can find ppl here in the classifieds that are selling their used parts...check nasioc.com as well....other than that, major vendors including gruppe-s and mpj performance sell stuff like that tooooo but mach III performance is my favorite!!! ask for henry if u go with mach III performance... :banana:

 

thanks, where and how do i get ahold of mach III?

 

you can get them at pretty much any vendor, hell, Summit Racing sells most the stuff you'd need.....

you need to look further into your misfire issue....I highly doubt there anything wrong with your motor....blowby is normal for these engines...invest in a catch can...do a compression check, that will verify your 'bad' engine...

misfires can be caused by bad spark plugs, coil packs, bad fuel filter, etc....

 

i have a catch can installed. i took the plugs out and the were fouled up pretty bad. i had the fuel filter changed at 30k miles. i only have 35k on the car. i will do a compression test later this week. i highly doubt there is anything wrong either but i am a noob with subies. i do see a lot of oil around the turbo and underneath the car. ive had two shops look at it with the same results. i do notice power loss through the power ban though, so im a little lost for any other problems but the rings are sealing.