JDM Godspeed downpipe to USDM exhaust fitment?
#1
Registered User
Thread Starter
iTrader: (15)
Join Date: Jul 2006
Location: North Bay Area
Posts: 281
Car Info: 2004 WRX Waggin'
JDM Godspeed downpipe to USDM exhaust fitment?
I am getting a Godspeed JDM Spec downpipe/midpipe which is a one piece pipe replacing the stock downpipe, midpipe and both cats. Will I be able to connect a USDM catback exhaust system to this and have it fit? I know there are some length differences between JDM/USDM exhaust components, but I've read that after the midpipe/last cat, the length of the rear pipe, muffler, etc. is equal in length. Can anyone clarify this?
#2
Registered User
Thread Starter
iTrader: (15)
Join Date: Jul 2006
Location: North Bay Area
Posts: 281
Car Info: 2004 WRX Waggin'
Updated question.
So from what I've read, I guess a USDM catback is slightly shorter than a JDM catback because of the downpipe length differences? So what if I had a shop make me a small bolt on pipe adapter/lengthener to bridge the gap between the JDM downpipe and the USDM catback? That should allow me to run the JDM downpipe with either JDM or USDM catbacks, correct? Does anyone know if this would work?
Thread
Thread Starter
Forum
Replies
Last Post
SsTiNgEr77
Used Aftermarket Car Parts For Sale
6
05-09-2004 03:36 PM