blitz nur spec PRESCRIPTION STRENGTH
Thread Starter
Registered User
Joined: Mar 2003
Posts: 36
From: oakland, ca
Car Info: Silver 03 WRX wagon
blitz nur spec PRESCRIPTION STRENGTH
anyone have any thoughts on the new blitz nur spec RX? i just took off my nur spec-r in hopes of slapping on a quieter cat back. i had my mind set on the fujitsubo power getter, but i just noticed the introduction of the RX. anyone runnin this set up? or know of a sound clip? thoughts? thanks!
Thread Starter
Registered User
Joined: Mar 2003
Posts: 36
From: oakland, ca
Car Info: Silver 03 WRX wagon
nothin? i love my blitz, but its goin bye bye for somethin quieter. this seems like the logical step. fujitsubo power getter i like, but not the angled exit. rmo1a is just bank. any thoughts?
VIP Member
iTrader: (24)
Joined: Jun 2005
Posts: 2,708
From: Modesto/Sacramento
Car Info: 07' AW 335i & 05' WD Escalade
https://www.i-club.com/forums/showth...35#post1607535
Buy it. Hes a good seller and 480 is dirt cheap for an rmo1a. i've seen them sell for $600 used. That used to be my exhaust. I can vouch for him
Buy it. Hes a good seller and 480 is dirt cheap for an rmo1a. i've seen them sell for $600 used. That used to be my exhaust. I can vouch for him
VIP Member
iTrader: (24)
Joined: Jun 2005
Posts: 2,708
From: Modesto/Sacramento
Car Info: 07' AW 335i & 05' WD Escalade
Theres only one dent and it doest effect the inner diameter of the piping at all. You should think about it
. I have a blitz nur spec R on my car right now too. I just switched from being too quiet (rmo1a) to loud (blitz).
The power getter is a nice exhaust. Not too loud or too quiet.
. I have a blitz nur spec R on my car right now too. I just switched from being too quiet (rmo1a) to loud (blitz). The power getter is a nice exhaust. Not too loud or too quiet.
Thread
Thread Starter
Forum
Replies
Last Post
Choku Dori
NorCal Classifieds
13
Aug 26, 2007 05:15 PM
Rex-29t
Engine/Power - EJ20T (pre-2006 WRX and JDM)
8
Jan 14, 2004 01:11 AM
jiveturkey
For Sale by Members
1
Aug 27, 2003 11:52 PM



