according to the utec manual, the utec's spare solenoid provides 2a max power. the relay for the NX kit that i have is a 60a relay (as per the instructions). anyone know where i can find a relay or something that will allow the utec to send the correct signal to the relay to power on the solenoids for the nitrous kit? or am i looking at this wrong?

i know the utecs parameters are being met because im getting a "SOLENOID: ON" and i know the relay and solenoids are wired properly because if i take the signal wire (that should be hooked to the utec) and connect it straight to a 12v, both solenoids activate.

any help is much appreciated!

is any of this sounds dumb, i should note that I know very little about wiring and what not. i'm just trying to get suggestions as to why it's not working...

 

bump