Greddy perf E-01
#2
not too sure about installations but to set the boost you will go on automatic boost set and set on how much boost you want for low and high and so on......but the trick is to step in full throttle on third gear until the meter hits the desired boost level.....you might to repeat until the little blinking icon on the screen dissapears ....that means that the boost is now saved ....good luck!
Thread
Thread Starter
Forum
Replies
Last Post
mr. m
Engine/Power - EJ25T (STI and 2006+ WRX)
48
04-20-2004 08:59 PM
gqhotnoodle
Engine/Power - EJ20T (pre-2006 WRX and JDM)
0
04-22-2003 07:53 PM