Any ProDrive Stage 2 Kit Experience to Share
Guest
Posts: n/a
Any ProDrive Stage 2 Kit Experience to Share
At about $1500.00 the Prodrive stage 2 kit is recommended by
a local tuner tuner for good bang vs. buck.
It also seems as if they did their homework regarding 91 octane
and maintaining driveability, reliability and so on.
Does anyone have experience with the prodrive kits they can
share ?
As understand it stage 2 is exhaust, firmware flash and upipe.
I know Prodrive prepares the WRC Rally cars but do they
do a good job "sorting things out" for humble USA spec
WRXs ?
a local tuner tuner for good bang vs. buck.
It also seems as if they did their homework regarding 91 octane
and maintaining driveability, reliability and so on.
Does anyone have experience with the prodrive kits they can
share ?
As understand it stage 2 is exhaust, firmware flash and upipe.
I know Prodrive prepares the WRC Rally cars but do they
do a good job "sorting things out" for humble USA spec
WRXs ?
Why would you buy it for $1500.00. when I sell them for $1270.00. Here is the latest dyno chart.
Mike
www.subaruxtras.com
Mike
www.subaruxtras.com
I have a set of instruction for the whole exhaust from the service manuals but it is over kill. I can fax them if you have a fax. Here what you need to do
1) remove muffler 2 bolts and 2 nuts
2) install new muffler 2 bolts and 2 nuts
3)remove the center section 4 bolts and nuts
4) remove the heat shields 8 bolts and nuts
5) put heat shields on new center setion 8 bolts
6) install new center section 8 bolts and nuts
now the intercooler
1)remove the 2 mounting bolt on top
2)disconnect the 2 hose on the left side
3) disconnect the hose on the right side of the ic
4) remove the 2 bolts on the bov
5) remove the clamp on the single eng of the y pipe and remove.
take out the intercooler and flip over and remove the y pipe.
I hope this helps most of my customer in stalls these kit in there driveway with ramps or jack stands
Mike
1) remove muffler 2 bolts and 2 nuts
2) install new muffler 2 bolts and 2 nuts
3)remove the center section 4 bolts and nuts
4) remove the heat shields 8 bolts and nuts
5) put heat shields on new center setion 8 bolts
6) install new center section 8 bolts and nuts
now the intercooler
1)remove the 2 mounting bolt on top
2)disconnect the 2 hose on the left side
3) disconnect the hose on the right side of the ic
4) remove the 2 bolts on the bov
5) remove the clamp on the single eng of the y pipe and remove.
take out the intercooler and flip over and remove the y pipe.
I hope this helps most of my customer in stalls these kit in there driveway with ramps or jack stands
Mike
Thread
Thread Starter
Forum
Replies
Last Post
casualsurfer
Engine/Power - EJ20T (pre-2006 WRX and JDM)
9
May 3, 2004 03:24 PM
useful
Interior, Exterior & Lighting
3
Jan 23, 2004 01:46 AM



