4eat problemo?
#1
VIP Member
Thread Starter
iTrader: (14)
Join Date: May 2003
Location: Wherever Sucks the Most
Posts: 8,675
Car Info: 2003 WRX, 2008 Camry
4eat problemo?
I have a 4eat tranny (14000miles) with redline d4ATF, hayden 403 tranny cooler. As far as mods are concerned all i have is a catback.
When i accelerate at about 60% throttle to WOT the tranny seems to have a bit trouble going from 3rd to 4th. this has happened a few times in the past week. I could be merging on the freeway at freeway speeds and then all of the sudden im at about 70mph@ about 5000-5500 rpms and still in 3rd!? then if i let off the throttle the car shifts to 4th and everything is peachy.
Anyone here experience this? anyone have answers.
thanks, eric
When i accelerate at about 60% throttle to WOT the tranny seems to have a bit trouble going from 3rd to 4th. this has happened a few times in the past week. I could be merging on the freeway at freeway speeds and then all of the sudden im at about 70mph@ about 5000-5500 rpms and still in 3rd!? then if i let off the throttle the car shifts to 4th and everything is peachy.
Anyone here experience this? anyone have answers.
thanks, eric
#2
a little trouble? does it feel a bit like hesitation like the car kind of studders a bit before it shifts? if so, i have the same thing. im guessing its just time for a tune up.
the tranny cooler did you install that yourself? i remember you pmed me about help installing it but i still havent installed it yet.
the tranny cooler did you install that yourself? i remember you pmed me about help installing it but i still havent installed it yet.
#3
VIP Member
Thread Starter
iTrader: (14)
Join Date: May 2003
Location: Wherever Sucks the Most
Posts: 8,675
Car Info: 2003 WRX, 2008 Camry
Originally posted by ScoobyBoy
a little trouble? does it feel a bit like hesitation like the car kind of studders a bit before it shifts? if so, i have the same thing. im guessing its just time for a tune up.
the tranny cooler did you install that yourself? i remember you pmed me about help installing it but i still havent installed it yet.
a little trouble? does it feel a bit like hesitation like the car kind of studders a bit before it shifts? if so, i have the same thing. im guessing its just time for a tune up.
the tranny cooler did you install that yourself? i remember you pmed me about help installing it but i still havent installed it yet.
I installed the tranny cooler about 3 months ago and everything seems to be working fine. I don't have a temp gauge hooked up to it but it has to be doing its intended job.
eric
#6
VIP Member
Thread Starter
iTrader: (14)
Join Date: May 2003
Location: Wherever Sucks the Most
Posts: 8,675
Car Info: 2003 WRX, 2008 Camry
Originally posted by ScoobyBoy
you think you can write me up step by step instructions on how to install it? ive checked out projectwrx's site and am still not too clear on how to install it. thanks.
you think you can write me up step by step instructions on how to install it? ive checked out projectwrx's site and am still not too clear on how to install it. thanks.
1)put the front wheels on ramps and let the car cool (duh)
2) take the tranny cooler and connect the fuild lines to the actual cooler but don't trim the hoses to length yet.
3) mount the tranny cooler on the left side of the radiator (as you're looking at it)... this would be the right side of the radiator as you sit in the car. Us the the nylon zip ties and punch them through the cooler and radiator, then secure them and trim the excess.
4) get on your back and you'll see a heatsheild mounted under the radiator next to the headers. take that sheild off!
5) now that you have the sheild off look to the bottom right section on the radiator and you'll see a metal spout with a hose on it, that's where the tranny fuild exits after it has been cooled by the radiator. so to put in simple terms you're going to tap into it like a piece of wire.
6) hook-up the furthest hose of the tranny cooler to the spout i mentioned above. so what you've done is attach another cooling device after the radiator. then secure with the hose clamps.
7)now hook up the other remaining hose to the oem hose that was originally connected to the spout on the radiator. you may need a 3" splicing type connector for this.
8)If you can get the heat sheild back on then more power to you! i left mine off because it caused the hoses to kink. don't worry because you have an added level of protection. just be sure to check the hoses for heat damage. mine seem to be fine after 11k miles still.
9)figure out how much empty volume you've created by adding the tranny cooler. look on the box to see how much space is inside the cooler itself.
10) with that measurement you'll add that much tranny fuild to the tranny via dipstick under the IC. You don't need to take off the IC, just get a long flexable funnel. I would recommend adding less fluid than you measured because the tranny dipstick is a tricky SOB and can fool you.
11)Start the car and let it warm up. With your foot on the brake go through every gear from P to 1st for about 30sec to 1minute. shut the car off and presto! you're done!
*you'll understand it A LOT better when you see what im talking about. you'll get the idea and run with it. Hope this helps.
eric
#7
glord thanks man. ive been wanting to install that sucker for the longest time, but was always too scared to tinker with it. hopefully ill have a go at it within the next two weeks.
you think its about time to replace the spark plugs? that has been my theory of why the car has been acting like that lately.
you think its about time to replace the spark plugs? that has been my theory of why the car has been acting like that lately.
#8
VIP Member
Thread Starter
iTrader: (14)
Join Date: May 2003
Location: Wherever Sucks the Most
Posts: 8,675
Car Info: 2003 WRX, 2008 Camry
Originally posted by ScoobyBoy
glord thanks man. ive been wanting to install that sucker for the longest time, but was always too scared to tinker with it. hopefully ill have a go at it within the next two weeks.
you think its about time to replace the spark plugs? that has been my theory of why the car has been acting like that lately.
glord thanks man. ive been wanting to install that sucker for the longest time, but was always too scared to tinker with it. hopefully ill have a go at it within the next two weeks.
you think its about time to replace the spark plugs? that has been my theory of why the car has been acting like that lately.
#9
im not too sure how valid the theory is either. im at 30k already with only one tranny fluid change, no diff fluid changes, and many many oil changes. ive just been noticing the shuddering recently, and the only thing i can think of is probably the plugs. just my theory of course. how often should i do the plugs? i heard every 50 or 60k from some people, but each car is different.
you have any theories? us 4eat's have to stick together. hahaha
you have any theories? us 4eat's have to stick together. hahaha
#10
VIP Member
Thread Starter
iTrader: (14)
Join Date: May 2003
Location: Wherever Sucks the Most
Posts: 8,675
Car Info: 2003 WRX, 2008 Camry
Originally posted by ScoobyBoy
im not too sure how valid the theory is either. im at 30k already with only one tranny fluid change, no diff fluid changes, and many many oil changes. ive just been noticing the shuddering recently, and the only thing i can think of is probably the plugs. just my theory of course. how often should i do the plugs? i heard every 50 or 60k from some people, but each car is different.
you have any theories? us 4eat's have to stick together. hahaha
im not too sure how valid the theory is either. im at 30k already with only one tranny fluid change, no diff fluid changes, and many many oil changes. ive just been noticing the shuddering recently, and the only thing i can think of is probably the plugs. just my theory of course. how often should i do the plugs? i heard every 50 or 60k from some people, but each car is different.
you have any theories? us 4eat's have to stick together. hahaha
#15
Originally posted by ScoobyBoy
tranny cooler install fest! ill drive up to davis for it.
tranny cooler install fest! ill drive up to davis for it.