i dont have his number, i'll try to find it for you.

 

Ya, surprisingly there is no hate at all on here. Gotta love i-club! Within a few minutes of posting something like this on Nasioc you would have gotten a barrage of hate posts saying how this is stupid and looks ghey and that you're some punk kid who doesn't know anything about his car.

Don't listen to the wheel bearing BS either. If you're only cruising on roads then you'll be fine. But if you race, no matter what offsets you run, your bearings will prematurely fail.

I can't hate at all since I used 15mm spacers with BBS's, and had two sets of low offset wheels. Like I sadi. It looks great. Especially on your car! But I just wish they didn't mess with the handling.


PS, it's super easy to roll your rear fenders with a baseball bat and a heat gun. I did it.

 

Hit up Daniel from SSAuto in Salida. He rolled my front and rear fenders and I think I paid 50 or 75 bucks and I have no complaints with him having rolled my fenders.

 

might have to do that! did he use the rooler tool and a heat gun?

 

lol i don't see any hating either.

Is RLLYRCR trying to start drama?

hrmm.....

 

Which kit did you purchase?

 

Ya ed he uses a roller and gun. That's how we did mine. If you end up going that route pm me and I can set you up with him.
U can even check out my fenders if you want before you make a decision.

 

im a go after work.. around 330 today if he has time

 

Nice. Post up how it went bro. I called D and u were there gettin them rolled.

 

oh this is going to be sweeet!

 

yup yup!!!

thanks rob for the recommendation... D hooked it up and turns out we share allot of old friends in the car world so it was nice to shoot the breeze.

i know i will DEFIANTLY be stopping by SSautoPOWER.COM before driving down to the bay from now on... very trust worthy and subie knowledgeable!

D isn't your average bs'er, hes an accomplished RACER himself (and im not talking street racing ) that basically has opened up a shop to help other car peeps.

two thumbs up! thanks D! and hope to do lunch again sometime! btw gerry says WAZUP!

 

http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWNX%3AIT

25mm which is 1 inch give or take you might think they are cheap crappys but they are NOT!

CNC Machined
6061 Billet Aluminum
Made in the U.S.A

how can you go wrong?

 

D at SSauto is running a 2inch yes thats 50mm spacer on his drift car! haha so yes id say they are safe! lol

oh and... its the same as the one i bought off ebay

 

glad it went well bro. lookin foward to checkin out the ride this weekend at the meet

 

Did you get one with extended studs? Or one of the bolt on ones?