after engine install questions?? any help?
Thread Starter
Registered User
iTrader: (1)
Joined: Oct 2003
Posts: 71
From: Danville
Car Info: 2002 Subaru Impreza WRX - WRB
after engine install questions?? any help?
hey guys... I just finished installing my new motor (my old one had a cracked block at 83000 miles) but... now i have a few small quirks with the car...
1. Power Steering... (i can move the wheel side to side and it has some type of power assist, but it feels choppy... like it has assist, and then it doesnt... steering fluid resivoir is filled to level, and still nothing...) could it have some air bubbles in the lines after i hooked them up? i thought these would cycle out....?
2. Engine h20 Temp gauge. The one with the weird looking "F"... this climbs pretty high, and then levels off where it always used to... but i don't remember it climbing that high before... any suggestons?
Thanks!
1. Power Steering... (i can move the wheel side to side and it has some type of power assist, but it feels choppy... like it has assist, and then it doesnt... steering fluid resivoir is filled to level, and still nothing...) could it have some air bubbles in the lines after i hooked them up? i thought these would cycle out....?
2. Engine h20 Temp gauge. The one with the weird looking "F"... this climbs pretty high, and then levels off where it always used to... but i don't remember it climbing that high before... any suggestons?
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
schafer
Sacramento & Reno
11
Jan 15, 2005 05:21 PM
schafer
Engine/Power - EJ20T (pre-2006 WRX and JDM)
4
Jan 15, 2005 02:21 PM
spdkills
Suspension, Handling, and Brakes
5
May 23, 2003 09:41 AM



