We have just received a shipment of the New hush system featuring spec's such as,

3" construction
Full Stainless 304
Dual 3" tips
Quiet design

*No Longer shipping with KB hangers*

To view pictures and order online please click here

Pricing is $485 shipped.

Shipping included is to the lower 48 states only.

CA folks please add 8.25% for sales tax.

Mike

(510) 487-4447
www.mpjperformance.com
www.gb-motorsports.com

 

Hey All,
Just had this system installed last Friday. It's quiet allright. At idle, a nice low rumble, at driving speeds the note is low, but not attracting attention. The twin pipes tuck in nice and tight below the bumpers lines. Overall happy with it, previously had the Tanabe Hyper medallion and it wasnt too loud, just the tail pipe was too huge. mike at MPJ and Andrew another fine job!

Bill

 

Glad you like it Bill, Great exhaust for those that want the power and flow of a 3" system but without the look at me loudness.

Mike

(510) 487-4447
www.mpjperformance.com
www.gb-motorsports.com

 

It would be nice to get some feed back from you folks/customers out there with a catless system using the Borla Hush to see what the exhaust note sounds like with the Borla system. That's my next move so I'm waiting to see/hear.
Bill

 

Bump for MPJ and a great Exhaust, I heard it on bills car and it looks and sounds SWEET.

-Zoeb

 

02BlackWRX - Thanks Zoeb

Mike

(510) 487-4447
www.mpjperformance.com
www.gb-motorsports.com

 

just interested if this will fit a 04rs? thnx

 

bob25rs - We have been informed that it will fit the 04RS fine.

Mike

(510) 487-4447
www.mpjperformance.com
www.gb-motorsports.com

 

If it can fit a 04 RS then can it fit a 02RS, and if it does would you guys be able to get me the borla headers included with a good deal.

 

sadbanker - The Hush system and 2.5 Headers would be $755 shipped.

Mike

(510) 487-4447
www.mpjperformance.com
www.gb-motorsports.com

 

Will this system fit a 99 2.5rs with minimal modification.

gm

 

greenemac2003 - You would have to switch one of the hangers for sure, as far as the rest I think it will match up but have not done it on a car other than a couple of WRX conversions that were running WRX downpipes.

Mike

(510) 487-4447
www.mpjperformance.com
www.gb-motorsports.com

 

Are those circle clamps for holding the exhaust together??? It's not bolted together? I really want this system but I don't want to put an exhaust on my car that just slides together and is clamped into place. Any way to get it to just bolt right up?

 

jdmpwrdr - The Borla system uses slip joint fitment and clamps to seal the joint, the system does bolt right up so to speak. The same joints are used on a lot of the JDM systems like Kakimoto and so on..

Mike

(510) 487-4447
www.mpjperformance.com
www.gb-motorsports.com

 

Will this piece work with a JDM down pipe?