Driving without endlinks
Thread Starter
Registered User
iTrader: (1)
Joined: May 2003
Posts: 454
From: San Diego, CA
Car Info: 04 WRX
Driving without endlinks
Here is the short story of my problem. I drove the car around the block and notice a clunking noise. When I pulled into my drive I looked into the car and notice that my top bolts on the passenger and driver side endlinks gone! The subaru dealers by in San Diego dont care this item in stock and have to order it. Does anyone know if it is ok to drive the car without the endlinks on the car while I wait for the replacement bolts?
Registered User
iTrader: (4)
Joined: Mar 2003
Posts: 3,670
From: East Bay / Pomona
Car Info: '02 PSM WRX
One of the bolts came off on my endlinks, and I've been driving around for a while. Nothing is really bad about it, except you may experience a lot of chassis roll and (i'm guessing it's your rears) massive understeer.
Also I don't think these bolts are just bolts. They need to be a certain hardness IIRC, and they're only 2.50 from a suby dealer of you can get them from subaruparts.com for around the same price.
Also I don't think these bolts are just bolts. They need to be a certain hardness IIRC, and they're only 2.50 from a suby dealer of you can get them from subaruparts.com for around the same price.
Thread
Thread Starter
Forum
Replies
Last Post
calisti
Used Aftermarket Car Parts For Sale
0
Jun 20, 2006 02:44 PM
calisti
New Aftermarket Car Parts For Sale
0
Jun 19, 2006 03:13 PM
Vishnu
Engine/Power - EJ25T (STI and 2006+ WRX)
1
Nov 11, 2004 10:00 AM




